To release a gate only after a passed ESD test, the factory must evaluate identity, access permission and the required wrist-strap and footwear results together. The terminal applies the approved rule for that person or area. It sends a single release command only when the identity is valid, every required test is complete and the result passes; otherwise, access remains blocked and the reason is recorded.
The operational problem
A stand-alone tester may show a pass, but it does not establish who was tested, which rule applied or whether an unqualified person was stopped. A controlled ESD entrance must bind identity, the required test mode, measured result and passage event.
Approaches for different sites
- Use an integrated identity and ESD terminal at a single entrance.
- For multiple protected areas, manage people, permissions and device rules centrally.
- Assign wrist-strap and left/right footwear tests by role rather than applying one mode to everyone.
- When retaining an existing gate, first verify its control input, single-release behaviour and status feedback.
Recommended workflow
Identify the person → load shift, area permission and test mode → perform the required tests → evaluate the approved rule → issue one release command on a pass → keep the entrance blocked and show a reason on a fail → retain identity, device, measured result, decision and passage status.
Required equipment and software
- Card or face identity terminal
- Wrist-strap and dual-foot test components
- Integrated ESD terminal or ESD flap barrier
- Access or gate controller
- Management software for people, rules, devices, records and reports
Checks before implementation
- Approved test modes and thresholds for each role or area
- Identity method and employee-number mapping
- Interfaces available from current access, attendance, HR or card systems
- Entrance direction, shift peaks, dressing sequence, network and power
- Procedures for failures, offline devices, visitors and emergency egress
Frequently asked questions
Does every passed test automatically open the gate?
No. A complete decision normally checks identity, area permission, validity, assigned test mode and the current result. A person who passes the ESD test but lacks permission for that area should still be denied.
Can the existing passage gate be retained?
Possibly. Its control input, one-person release logic, status feedback and emergency requirements must be checked first. A suitable existing gate can then be linked to the ESD terminal.
Can managers review wrist and footwear test records?
Yes, when a networked ESD terminal binds the test to an identified person. Records can be searched by person, device, time, test item and decision; the retained fields and period should be agreed in the implementation scope.